Analisis Pengendalian Kualitas pada Proses Coating Project Fabrikasi Metal Ducting MBI di PT. Swadaya Graha Menggunakan Metode FMEA

Melanida Agustin; Akmal Suryadi

doi:10.59581/jkts-widyakarya.v2i1.2140

Authors

Melanida Agustin Universitas Pembangunan Nasional “Veteran” Jawa Timur
Akmal Suryadi Universitas Pembangunan Nasional “Veteran” Jawa Timur

DOI:

https://doi.org/10.59581/jkts-widyakarya.v2i1.2140

Keywords:

Coating, Defect, Failure Mode Effects Analysis (FMEA)

Abstract

. This research was conducted to analyze the quality of the coating process at PT Swadaya Graha using the Failure Mode Effects Analysis (FMEA) method. Primary and secondary data collection was carried out in this research. The research results showed that there were five types of defects, namely polishing marks, orange peel, dustpray, sagging and cracking. Based on the FMEA method, the defect rating is determined based on the resulting cumulative percentage value where the highest value is obtained for orange peel defects at 41.7%. This defect was analyzed and it was found that one of the causal factors was the incorrect application of the spreading rate. This factor is obtained from an RPN value of 120. From this research it can be concluded that the FMEA method can be used as a tool to minimize defects in the coating process and analyze improvements that should be prioritized..

References

Adiansyah, M., Kasir., & Junaidi, M. W. (2021). Pengaruh Tekanan Udara Sandblasting Terhadap Kekasaran Permukaan Pada Baja Karbon ST 60.

Aruan, R. H., Pratikno, H., & Hadiwidodo, T. S. (2023). Analisa Pengaruh Suhu Material Pada Pengaplikasian Coating Epoxy Terhadap Kekuatan Adhesi Baja. Jurnal Teknik ITS, 12 (1), 34-40.

Hanif, R. Y., Rukmi, H. S., & Susanty, S. (2015). Perbaikan Kualitas Produk Keraton Luxury Di PT.X Dengan Menggunakan Metode Failure Mode and Effect Analysis (FMEA) dan Fault Tree Analysis (FTA). Jurnal Online Institut Teknologi Nasional, 3 (3), 137-147.

Islahudin, N. (2019). Teknologi Proses Pengecatan Menggunakan Sistem Atomisasi Pada Produk Berbahan Plastik Di Industri Perakitan Sepeda Motor. SINTEK JURNAL: Jurnal Ilmiah Teknik Mesin, 13 (1), 15-25.

Jotun Paints. (2006). Technical Data Protective Coatings Version 1/99. Cikarang Barat.

Suherman, A., & Cahyana, B. J. (2019). Pengendalian Kualitas Dengan Metode Failure Mode Effect and Analysis (FMEA) Dan Pendekatan Kaizen untuk Mengurangi Jumlah Kecacatan dan Penyebabnya. Seminar Nasional Sains dan Teknologi: Universitas Muhammadiyah Jakarta.